Static Drawdown

    Category

    Prop Trading & Funded Accounts

    Sub-category

    Drawdown-Typen bei Prop Firms

    Curated by

    GlanWick Team

    Last reviewed

    · Methodology

    A static drawdown is a fixed loss limit used by prop firms: it sits unchanged below the starting capital, no matter how high equity climbs in between. On a $100,000 account with a 10 % static drawdown, equity may never fall below $90,000. Profits enlarge the usable buffer because the floor stays put – the milder alternative to a trailing drawdown.

    Context & Mechanics

    How it works

    The static drawdown is the simplest form of the overall loss limit at a prop firm: the loss floor is set once at the start – typically 8–10 % below the starting capital – and never moves afterwards. On a nominal $100,000 account at 10 %, the floor sits permanently at $90,000. If equity rises to $106,000, the usable buffer grows to $16,000; the floor itself stays put.

    How it differs from a trailing drawdown

    The difference to a trailing drawdown is economically significant: there, the floor ratchets up with every equity high, so interim profits do not permanently enlarge the buffer. With a static drawdown, realised profits act like a self-built safety cushion. Historically, many two-step challenges use static total limits, while one-step and instant-funding models more often apply trailing logic – the exact design varies by provider.

    Calculation details

    Definitions decide here too: does equity including open positions count, or only balance? Is the floor checked intraday or only at end of day (EOD)? Does the percentage refer to the starting capital or – more rarely – to the previous day's balance? A trader who cannot answer these three questions does not know their actual limit. The daily loss limit applies additionally and independently.

    Why it matters for traders

    A static drawdown rewards a conservative start: building an early profit cushion means trading with considerably more room afterwards – a structural advantage over trailing accounts, where the distance stays constant. The most common mistake is nevertheless the same: reading the buffer as a licence for bigger positions instead of managing it as a reserve. The GlanWick simulator lets traders compare static and trailing loss floors directly – GlanWick is a training and simulation tool and not a prop firm itself.

    Execution Example

    A trader runs a two-step challenge on a nominal $100,000 account with a 10 % static drawdown (fixed floor $90,000, equity basis, checked intraday) and a 5 % daily loss limit.

    1. Start: equity $100,000, fixed floor $90,000, buffer $10,000.
    2. A winning streak lifts equity to $106,000 → the floor stays at $90,000; the buffer grows to $16,000.
    3. A multi-day losing phase down to $91,500 → the account survives (remaining buffer $1,500); no single day breaches the $5,000 daily loss limit.
    4. A further daily loss of −$2,000 pushes equity to $89,500 → floor breached, challenge ended. With a trailing floor (after the $106,000 peak: floor $96,000) the account would already have failed at $96,000.

    Execution Risk & Errors

    1

    Confusing the provider's static and trailing drawdown

    2

    Reading the profit cushion as a licence for bigger positions

    3

    Not distinguishing equity and balance basis of measurement

    4

    Not knowing whether checks are intraday or end of day

    5

    Losing sight of the daily loss limit that applies in addition

    Frequently Asked

    What is the difference between a static drawdown and the overall loss limit?

    The overall loss limit is the umbrella term for the total loss cap; a static drawdown is the variant where that cap sits fixed below the starting capital and does not move.

    Do profits enlarge my buffer under a static drawdown?

    Yes. Since the floor stays put, the usable distance grows with every realised profit – the key difference to a trailing drawdown, where the distance stays constant.

    Is a static drawdown better for traders?

    Historically the static variant is considered milder because profits permanently increase the room to manoeuvre. Providers sometimes compensate with stricter other rules – the overall comparison matters.

    Can I compare static and trailing conditions in advance?

    Yes. The GlanWick simulator lets you run both drawdown variants with identical parameters risk-free and compare them directly.

    This Website Uses Cookies

    We use technically required cookies so the platform works. Optional cookies are only set with your explicit consent.

    Legal basis: Art. 6(1)(a) GDPR. You can withdraw your consent at any time via the "Cookie Settings" link in the footer.

    More information in our Privacy Policy · Imprint